Sportbike World banner

1 - 3 of 3 Posts

·
Registered
Joined
·
265 Posts
Discussion Starter #1
Hey all,

I just upgraded my bike to the 954 front end with the upside down forks. I used a RC51 6 spoke front wheel, and the rotor is touching the caliper body on the right side. I either need to machine down the hub so the rotors sit further inward by about 2-3mm, and/or I could machine the caliper mount on the fork to bring the caliper outward.

Does anybody know a good machine shop that can do this job and won't try to rip me off in the process?

Thanks!

Sime
 

·
Best ET 7.77 @ 186mph
Joined
·
6,322 Posts

·
Registered
Joined
·
2,254 Posts
do the calipers sit inside or outside of the fork legs? check your pm's Sime
 
1 - 3 of 3 Posts
Top