Sportbike Forum: Sportbike Motorcycle Forums - Reply to Topic
Thread: Slip-on and re-jetting question Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Sportbike Forum: Sportbike Motorcycle Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
05-31-2002 02:24 PM
RayO Not a stupid question, but covered in at least one earlier thread.

Re-jetting refers to changing the air/fuel mixture on a carburetor in one or more of 3 different ways: changing the size of the small device that meters the gas (jet) in the pilot (idle and just off-idle) and/or main flow, adjusitng the pilot mixture screws, or adjusting (usually with a shim) the most closed position of the needle valve that regulates the flow of fuel with throttle position.

This is done to improve performance (get rid of flat spots at certain rpms, or compensate for a new exhaust) and can become a never-ending process if you get really picky about it. I believe that most fuel injected bikes allow electronic (PROM) changes for this.
05-31-2002 01:53 PM
infamus333 sorry if this is a stupid question, but what is meant by re-jetting a bike?
05-31-2002 12:18 PM
RayO Don't know about the specifics of your Katana or V&H, but if a manufacturer says that their slip-on does not require re-jetting on your bike, then you should be OK. MC's run lean (lowish fuel to air ratio) in order to pass smog. Almost any aftermarket exhaust is less restictive than stock so more air/fuel is run through the engine. Usually this means that more fuel needs to be run through the carbs to match up with more intake air. Re-jetting to larger jets increases the fuel to air ratio. If the slip-on is not significantly less restrictive, then no more fuel is needed. Check your pipe for residue color after the new pipe has been run some. If it's white/light grey (or if it the exhaust "pops" or backfires a lot), you're probably too lean and probably should re-jet. If it's dark grey, then OK. If really black/sooty, then too rich.
05-31-2002 10:53 AM
wayjay66
Slip-on and re-jetting question

I have looked at different "slip-on" cans and was just curious.
1. Which one is best performer and sounding?
2. I saw in Vance & Hines site that for the SS2-R it is not mandatory to re-jet the carbs. Is this a step I should have done? What is difference if I do vs. Don't?

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome